Course Outline Module 1: Cisco Wireless LAN Essentials Refresher Lesson 1: High level review of prerequisite course - Defining Cisco Wireless LAN Essentials Module 2: Pre-Deployment Planning Lesson 1: Successful Wireless Deployments and Pre-deployment Planning Lesson 2: Cisco WLAN Professional Services Lesson 3: Spectrum Expert Lesson 4: PI Planning tools Module 3: Autonomous Deployments Lesson 1: Easy Setup GUI Interface Lesson 2: Basic Setup via CLI Lesson 3: Access Point Modes Lesson 4: Bridge Modes Lesson 5: Non-Client serving Modes Module 4: Unified Deployments Lesson 1: Initial controller Setup, and configure basic settings Lesson 2: Modes of operation available for a unified access point Lesson 3: Mechanisms by which an AP associates to a WLC Lesson 4: User Interfaces to the System Lesson 5: Radio Resource Management and CleanAir Lesson 6: Administering WLANs and AP Groups Lesson 7: Configuring Quality of Service Lesson 8: IPv6 Support Lesson 9: Identify and Configure the Wireless LAN Lesson 10: Security Parameters Lesson 11: General Administration Lesson 12: Guest Access Module 5: FlexConnect Deployments Lesson 1: Benefits and Limitations of FlexConnect Architecture Lesson 2: Operational Differences between Lesson 3: FlexConnect and Unified Architectures Module 6: Wireless LAN Maintenance and Troubleshooting Lesson 1: Routine Maintenance Lesson 2: Policy Configuration and Management Lesson 3: Gathering Data Lesson 4: Troubleshooting in a Cisco Unified Wireless Network Module 7: Client Mobility Lesson 1: Same Subnet Roaming Lesson 2: Inter-subnet Mobility Module 8: High Density Deployment Challenges Lesson 1: Effects of Client Density on a Wireless Network Lesson 2: Planning for Areas of High Client Density Module 9: Implementing Mesh Network Lesson 1: Describe Wireless Mesh Networks Lesson 2: Mesh Network Formation Process Lesson 3: Implementing a Mesh Network for the Enterprise Lesson 4: Configuring Advanced Mesh Features Lesson 5: Troubleshooting a Mesh Network Lab Outline: Lab 1: Performing the Initial WLC Configuration Using the CLI Lab 2: Unified AP Modes of Operation Lab 3: AP Association Options Lab 4: Controller Web Interface Lab 5: Configuring RRM and CleanAir Lab 8: Configuring IPv6 First Hop Security Lab 9: Configuring Security Parameters on the WLC Lab 10: Configuring Guest Access and Web Authentication Lab 11: Configuring Mesh Access Points |